P0155 on Dodge Hornet
Factory diagnostic protocol and troubleshooting wire for fault code P0155 specifically for the Dodge Hornet (2023–2026, 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)).
1. Symptoms of P0155 on Dodge Hornet
When the Engine Control Module (ECM/PCM) on your Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)) logs fault code P0155, drivers commonly observe:
2. Most Likely Causes on Dodge Hornet
Historical warranty claims and technical repair bulletins for Dodge Hornet point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Hornet
Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Equipment for Diagnosing Dodge Hornet (P0155)
Dodge Hornet OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Dodge Hornet.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Hornet
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Hornet:
4. Dodge Hornet P0155 FAQs
What causes code P0155 to trigger on a Dodge Hornet?
On the Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)), P0155 is most frequently caused by Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.
Where is the OBD-II port located on my Dodge Hornet?
On the Dodge Hornet, the 16-pin DLC diagnostic connector is located Under driver steering column lower trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Hornet with code P0155?
Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Given that P0155 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.