C1288 on Dodge Hornet
Factory diagnostic protocol and troubleshooting wire for fault code C1288 specifically for the Dodge Hornet (2023–2026, 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)).
1. Symptoms of C1288 on Dodge Hornet
When the Engine Control Module (ECM/PCM) on your Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)) logs fault code C1288, drivers commonly observe:
2. Most Likely Causes on Dodge Hornet
Historical warranty claims and technical repair bulletins for Dodge Hornet point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Hornet
Monitor brake pressure transducer PID. It should read near 0 bar unpressed and climb smoothly to 80+ bar when pressing pedal. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Unplug ABS connector and check for bent pins or brake fluid contamination. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Replace the ABS HCU / pump assembly or send unit to a certified rebuilder to replace the internal pressure transducer. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Run scan tool automated bleed procedure to purge air from ABS valves, then bleed all 4 calipers. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Clear DTCs and road test to verify AdvanceTrac operation. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Equipment for Diagnosing Dodge Hornet (C1288)
Dodge Hornet OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Dodge Hornet.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Hornet
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Hornet:
4. Dodge Hornet C1288 FAQs
What causes code C1288 to trigger on a Dodge Hornet?
On the Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)), C1288 is most frequently caused by Failed internal brake pressure transducer inside the ABS Hydraulic Control Unit (HCU) or Corroded pins in ABS module electrical connector.
Where is the OBD-II port located on my Dodge Hornet?
On the Dodge Hornet, the 16-pin DLC diagnostic connector is located Under driver steering column lower trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Hornet with code C1288?
Caution. Normal hydraulic brakes work, but ABS, Traction Control, and AdvanceTrac are disabled. Given that C1288 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.