C0051 on Dodge Hornet
Factory diagnostic protocol and troubleshooting wire for fault code C0051 specifically for the Dodge Hornet (2023–2026, 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)).
1. Symptoms of C0051 on Dodge Hornet
When the Engine Control Module (ECM/PCM) on your Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)) logs fault code C0051, drivers commonly observe:
2. Most Likely Causes on Dodge Hornet
Historical warranty claims and technical repair bulletins for Dodge Hornet point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Hornet
Center steering wheel and perform SAS zero-point calibration using an advanced bi-directional scan tool. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Turn wheel lock-to-lock. Angle should smoothly track from -540° to +540°. If it drops out or reads 0° constantly, sensor is defective. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Disconnect battery, remove airbag and steering wheel, replace steering angle sensor assembly, reassemble and recalibrate. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Clear DTCs and verify traction control light stays off during test drive. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).
Equipment for Diagnosing Dodge Hornet (C0051)
Dodge Hornet OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Dodge Hornet.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Hornet
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Hornet:
4. Dodge Hornet C0051 FAQs
What causes code C0051 to trigger on a Dodge Hornet?
On the Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)), C0051 is most frequently caused by Faulty Steering Angle Sensor (SAS) in clockspring / steering column or Steering angle calibration lost after wheel alignment or battery disconnect.
Where is the OBD-II port located on my Dodge Hornet?
On the Dodge Hornet, the 16-pin DLC diagnostic connector is located Under driver steering column lower trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Hornet with code C0051?
Caution. ABS, StabiliTrak, and Electronic Stability Control (ESP) will be disabled. Given that C0051 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.