FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0442 on Dodge Charger: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0442 (EVAP System Small Leak Detected - Diagnosis & Repair Guide) specifically on the Dodge Charger (2020–2026, 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo).

Dodge Charger
DIY Parts Estimate
$25 - $200 (DIY: $15)
Charger OEM Fitment
Shop Labor Quote
$180 – $380
Based on $120/hr labor
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0442 On Another Dodge Model:
Dodge Charger

1. Symptoms of P0442 on Dodge Charger

When the Engine Control Module (ECM/PCM) on your Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo) logs fault code P0442, drivers commonly observe:

Check Engine Light on on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Intermittent faint fuel odor near rear wheel well on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Failed OBD-II smog check on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Dodge Charger OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash assembly next to hood lever. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Dodge Charger

Historical warranty claims and technical repair bulletins for Dodge Charger point to the following failure distribution:

55%
Worn or cracked gas cap rubber seal (Dodge OEM Part)
25%
Small split in charcoal canister vapor line (Dodge OEM Part)
12%
Leaking EVAP vent valve solenoid (Dodge OEM Part)

3. Step-by-Step DIY Repair Guide for Dodge Charger

01
Clean or Replace Gas Cap O-Ring

Inspect the gas cap gasket for micro-cracks or debris. Replace with OEM cap if hardened. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

02
Perform EVAP Smoke Machine Test

Inject mineral oil smoke into the EVAP service port to visually pinpoint the pinhole leak. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

03
Replace Vent Solenoid Valve

If smoke escapes from the canister vent, replace the stuck solenoid. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

Other Common Fault Codes on Dodge Charger

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Charger:

4. Dodge Charger P0442 FAQs

What causes code P0442 to trigger on a Dodge Charger?

On the Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo), P0442 is most frequently caused by Worn or cracked gas cap rubber seal or Small split in charcoal canister vapor line.

Where is the OBD-II port located on my Dodge Charger?

On the Dodge Charger, the 16-pin DLC diagnostic connector is located Driver lower dash assembly next to hood lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Dodge Charger with code P0442?

Safe to drive. Will not damage engine internals. Given that P0442 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.