P2004 on 2017 Dodge Charger
Technical troubleshooting wire for fault code P2004 specifically tailored for the 2017 Dodge Charger. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2017 Charger Symptoms
- Check Engine Light on
- Sluggish low-RPM acceleration and low-end torque loss
- Engine runs fine at high highway RPMs (3,500+ RPM)
- Slightly rough idle or minor intake whistling noise
Likely Root Causes on 2017 Charger
- Carbon buildup binding the intake manifold swirl flap runner plates
- Broken plastic IMRC actuator linkage rod or vacuum diaphragm
- Faulty electronic IMRC runner control motor / solenoid
- Cracked vacuum line to IMRC actuator
Step-by-Step Fix Protocol for 2017 Dodge Charger
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment P2004 set.
Inspect the sensor connector on the 2017 Charger engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC P2004 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2017 Dodge Charger (P2004)
2017 Dodge Charger OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for 2017 Dodge Charger.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.