P0420 on Dodge Challenger
Factory diagnostic protocol and troubleshooting wire for fault code P0420 specifically for the Dodge Challenger (2020–2026, 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)).
1. Symptoms of P0420 on Dodge Challenger
When the Engine Control Module (ECM/PCM) on your Dodge Challenger (3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)) logs fault code P0420, drivers commonly observe:
2. Most Likely Causes on Dodge Challenger
Historical warranty claims and technical repair bulletins for Dodge Challenger point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Challenger
Use a live-data scan tool. Downstream O2 sensor should show a steady voltage around 0.45V to 0.7V. If it fluctuates rapidly between 0.1V and 0.9V like the upstream sensor, the cat is not storing oxygen. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Check exhaust manifold gaskets and flex pipes before the catalytic converter. Extra air entering exhaust false-triggers the P0420 code. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
If the sensor is sluggish or older than 100,000 miles, replace the downstream oxygen sensor first before condemning the expensive catalytic converter. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Pour a designated catalytic cleaner (e.g. Cataclean) into 1/4 tank of fuel and drive 50 miles on the highway to burn off surface carbon deposits. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
If codes return after sensor replacement and cleaning, replace the catalytic converter with an EPA or CARB compliant unit. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Equipment for Diagnosing Dodge Challenger (P0420)
Cataclean Complete Engine & Catalytic Cleaner
Cleans catalytic converter, oxygen sensors, and fuel injectors to clear P0420/P0430 efficiency codes.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Challenger
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Challenger:
4. Dodge Challenger P0420 FAQs
What causes code P0420 to trigger on a Dodge Challenger?
On the Dodge Challenger (3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)), P0420 is most frequently caused by Catalytic converter internal substrate degraded or melted or Faulty Downstream Oxygen Sensor (O2 Sensor Bank 1 Sensor 2).
Where is the OBD-II port located on my Dodge Challenger?
On the Dodge Challenger, the 16-pin DLC diagnostic connector is located Under driver dash left of center stack. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Challenger with code P0420?
Yes for moderate distances, but vehicle will fail state emissions inspections. Given that P0420 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.