P0112 on Chrysler Voyager
Factory diagnostic protocol and troubleshooting wire for fault code P0112 specifically for the Chrysler Voyager (2020–2026, 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)).
1. Symptoms of P0112 on Chrysler Voyager
When the Engine Control Module (ECM/PCM) on your Chrysler Voyager (3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)) logs fault code P0112, drivers commonly observe:
2. Most Likely Causes on Chrysler Voyager
Historical warranty claims and technical repair bulletins for Chrysler Voyager point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chrysler Voyager
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0112 to note engine RPM, load, and voltage when the fault triggered. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Inspect the electrical connector and wiring harness related to P0112 for chafing, corrosion, moisture, or pin push-out. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Chrysler Voyager equipped with 3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic).
Equipment for Diagnosing Chrysler Voyager (P0112)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Chrysler Voyager.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chrysler Voyager
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chrysler Voyager:
4. Chrysler Voyager P0112 FAQs
What causes code P0112 to trigger on a Chrysler Voyager?
On the Chrysler Voyager (3.6L Pentastar V6 24V VVT (287HP / 9-Speed Automatic)), P0112 is most frequently caused by IAT sensor shorted to ground or Damaged wiring harness.
Where is the OBD-II port located on my Chrysler Voyager?
On the Chrysler Voyager, the 16-pin DLC diagnostic connector is located Driver lower kick panel near hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chrysler Voyager with code P0112?
Yes. ECM assumes intake air is 280°F+. Given that P0112 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.