P0335 on Chrysler Pacifica: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0335 (P0335: Crankshaft Position Sensor A Circuit Malfunction) specifically on the Chrysler Pacifica (2020–2026, 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV).
1. Symptoms of P0335 on Chrysler Pacifica
When the Engine Control Module (ECM/PCM) on your Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV) logs fault code P0335, drivers commonly observe:
2. Most Likely Causes on Chrysler Pacifica
Historical warranty claims and technical repair bulletins for Chrysler Pacifica point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chrysler Pacifica
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0335 is static or intermittent. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.
Visually inspect the physical component (Crankshaft Position (CKP) Sensor), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.
Other Common Fault Codes on Chrysler Pacifica
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chrysler Pacifica:
4. Chrysler Pacifica P0335 FAQs
What causes code P0335 to trigger on a Chrysler Pacifica?
On the Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV), P0335 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Crankshaft Position (CKP) Sensor) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Chrysler Pacifica?
On the Chrysler Pacifica, the 16-pin DLC diagnostic connector is located Beneath driver steering column bezel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chrysler Pacifica with code P0335?
No. Immediate shutdown / repair required to prevent permanent hardware destruction or total system lockup. Given that P0335 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.