FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0172 on Chrysler Pacifica: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0172 (System Too Rich (Bank 1) - Symptoms, Causes & Step-by-Step Fix) specifically on the Chrysler Pacifica (2020–2026, 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV).

Chrysler Pacifica
DIY Parts Estimate
$30 - $280 (DIY Clean: $15)
Pacifica OEM Fitment
Shop Labor Quote
$180 – $380
Based on $120/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0172 On Another Chrysler Model:
Chrysler Pacifica

1. Symptoms of P0172 on Chrysler Pacifica

When the Engine Control Module (ECM/PCM) on your Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV) logs fault code P0172, drivers commonly observe:

Check Engine Light on on Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV)
Strong unburnt fuel odor from exhaust on Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV)
Black carbon soot around exhaust tip on Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV)
Rough idle and engine bogging under throttle on Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV)
Noticeable drop in MPG on Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV)
Chrysler Pacifica OBD-II Port Location
The 16-pin diagnostic connector is located Beneath driver steering column bezel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Chrysler Pacifica

Historical warranty claims and technical repair bulletins for Chrysler Pacifica point to the following failure distribution:

55%
Faulty or leaking fuel injector (Chrysler OEM Part)
25%
Contaminated Mass Air Flow (MAF) sensor (Chrysler OEM Part)
12%
Stuck closed EVAP canister purge valve (Chrysler OEM Part)
8%
Excessive fuel pressure regulator failure (Chrysler OEM Part)

3. Step-by-Step DIY Repair Guide for Chrysler Pacifica

01
Clean MAF Sensor and Throttle Body

Use dedicated MAF cleaner to remove carbon buildup from sensor wires. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.

02
Check Short Term & Long Term Fuel Trims

Use live OBD-II scanner data; negative trims beyond -10% indicate the ECU is cutting fuel. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.

03
Inspect Fuel Injector Leak-Down

Perform a fuel pressure leak-down test to identify injectors leaking raw gasoline into cylinders while parked. on the Chrysler Pacifica equipped with 3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV.

Other Common Fault Codes on Chrysler Pacifica

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chrysler Pacifica:

4. Chrysler Pacifica P0172 FAQs

What causes code P0172 to trigger on a Chrysler Pacifica?

On the Chrysler Pacifica (3.6L Pentastar V6 (287HP) / 3.6L Plug-In Hybrid eFlite EV), P0172 is most frequently caused by Faulty or leaking fuel injector or Contaminated Mass Air Flow (MAF) sensor.

Where is the OBD-II port located on my Chrysler Pacifica?

On the Chrysler Pacifica, the 16-pin DLC diagnostic connector is located Beneath driver steering column bezel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Chrysler Pacifica with code P0172?

Driveable short distances, but unburnt fuel can damage catalytic converters. Given that P0172 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.