FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0022 on Chevrolet Equinox: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0022 (P0022: Camshaft Position - Timing Over-Retarded (Bank 2)) specifically on the Chevrolet Equinox (2020–2026, 1.5L Turbo 4-Cyl (LYX 175HP)).

Chevrolet Equinox
DIY Parts Estimate
$150 - $450 (DIY: $50 - $120)
Equinox OEM Fitment
Shop Labor Quote
$180 – $380
Based on $115/hr labor
Drivability Status
Drivable (Short Trip)
High urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0022 On Another Chevrolet Model:
Chevrolet SilveradoChevrolet EquinoxChevrolet TahoeChevrolet Corvette

1. Symptoms of P0022 on Chevrolet Equinox

When the Engine Control Module (ECM/PCM) on your Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP)) logs fault code P0022, drivers commonly observe:

System alert or indicator light illuminated (P0022) on Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP))
Intermittent performance throttling or unexpected operation halts on Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP))
Audible sensor relay clicking or anomalous status telemetry in dashboard logs on Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP))
Degraded operational throughput or error dialog popups on startup on Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP))
Readiness monitors failing state emissions or system compliance audits on Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP))
Chevrolet Equinox OBD-II Port Location
The 16-pin diagnostic connector is located Driver footwell above brake arm. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Chevrolet Equinox

Historical warranty claims and technical repair bulletins for Chevrolet Equinox point to the following failure distribution:

55%
Component aging, oxidation, or degraded internal circuit element (Bank 2 VVT Actuator) (Chevrolet OEM Part)
25%
Wiring harness abrasion, loose terminal pin, or ground voltage float (Chevrolet OEM Part)
12%
Outdated firmware microcode or incompatible software driver update (Chevrolet OEM Part)
8%
Thermal stress or excessive operational duty-cycle fatigue (Chevrolet OEM Part)
8%
Contamination from carbon buildup, moisture ingress, or dirty filtration (Chevrolet OEM Part)

3. Step-by-Step DIY Repair Guide for Chevrolet Equinox

01
Connect Diagnostic Scanner / Logging Monitor to Retrieve Telemetry

Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0022 is static or intermittent. on the Chevrolet Equinox equipped with 1.5L Turbo 4-Cyl (LYX 175HP).

Required Tool: Oil pressure gauge, Ratchet
02
Perform Physical & Electrical Circuit Inspection

Visually inspect the physical component (Bank 2 VVT Actuator), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Chevrolet Equinox equipped with 1.5L Turbo 4-Cyl (LYX 175HP).

Required Tool: Multimeter, Flashlight, Contact Cleaner Spray
03
Component Testing & Resistance / Voltage Verification

Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Chevrolet Equinox equipped with 1.5L Turbo 4-Cyl (LYX 175HP).

Required Tool: Oil pressure gauge, Ratchet
04
Execute Component Replacement or Software Configuration Patch

Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Chevrolet Equinox equipped with 1.5L Turbo 4-Cyl (LYX 175HP).

Required Tool: Standard Hand Tool Set / Terminal Commands
05
Clear Diagnostic Trouble Code & Complete Verification Drive Cycle

Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Chevrolet Equinox equipped with 1.5L Turbo 4-Cyl (LYX 175HP).

Required Tool: OBD-II Code Reader / Diagnostic Suite

Other Common Fault Codes on Chevrolet Equinox

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chevrolet Equinox:

4. Chevrolet Equinox P0022 FAQs

What causes code P0022 to trigger on a Chevrolet Equinox?

On the Chevrolet Equinox (1.5L Turbo 4-Cyl (LYX 175HP)), P0022 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Bank 2 VVT Actuator) or Wiring harness abrasion, loose terminal pin, or ground voltage float.

Where is the OBD-II port located on my Chevrolet Equinox?

On the Chevrolet Equinox, the 16-pin DLC diagnostic connector is located Driver footwell above brake arm. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Chevrolet Equinox with code P0022?

Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that P0022 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.