P0112 on Chevrolet Corvette
Factory diagnostic protocol and troubleshooting wire for fault code P0112 specifically for the Chevrolet Corvette (2020–2026, 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid).
1. Symptoms of P0112 on Chevrolet Corvette
When the Engine Control Module (ECM/PCM) on your Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid) logs fault code P0112, drivers commonly observe:
2. Most Likely Causes on Chevrolet Corvette
Historical warranty claims and technical repair bulletins for Chevrolet Corvette point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chevrolet Corvette
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0112 to note engine RPM, load, and voltage when the fault triggered. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.
Inspect the electrical connector and wiring harness related to P0112 for chafing, corrosion, moisture, or pin push-out. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Chevrolet Corvette equipped with 6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid.
Equipment for Diagnosing Chevrolet Corvette (P0112)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Chevrolet Corvette.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chevrolet Corvette
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chevrolet Corvette:
4. Chevrolet Corvette P0112 FAQs
What causes code P0112 to trigger on a Chevrolet Corvette?
On the Chevrolet Corvette (6.2L LT2 Small Block V8 (495HP) / 5.5L Flat-Plane Z06 (670HP) / E-Ray Hybrid), P0112 is most frequently caused by IAT sensor shorted to ground or Damaged wiring harness.
Where is the OBD-II port located on my Chevrolet Corvette?
On the Chevrolet Corvette, the 16-pin DLC diagnostic connector is located Driver footwell lower panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chevrolet Corvette with code P0112?
Yes. ECM assumes intake air is 280°F+. Given that P0112 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.