FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0172 on Cadillac Escalade-V: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0172 (System Too Rich (Bank 1) - Symptoms, Causes & Step-by-Step Fix) specifically on the Cadillac Escalade-V (2023–2026, 6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque)).

Cadillac Escalade-V
DIY Parts Estimate
$30 - $280 (DIY Clean: $15)
Escalade-V OEM Fitment
Shop Labor Quote
$180 – $380
Based on $165/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0172 On Another Cadillac Model:
Cadillac EscaladeCadillac Escalade-VCadillac CT5Cadillac CT5-V BlackwingCadillac XT5Cadillac Lyriq

1. Symptoms of P0172 on Cadillac Escalade-V

When the Engine Control Module (ECM/PCM) on your Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque)) logs fault code P0172, drivers commonly observe:

Check Engine Light on on Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque))
Strong unburnt fuel odor from exhaust on Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque))
Black carbon soot around exhaust tip on Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque))
Rough idle and engine bogging under throttle on Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque))
Noticeable drop in MPG on Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque))
Cadillac Escalade-V OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash assembly next to footwell light. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Cadillac Escalade-V

Historical warranty claims and technical repair bulletins for Cadillac Escalade-V point to the following failure distribution:

55%
Faulty or leaking fuel injector (Cadillac OEM Part)
25%
Contaminated Mass Air Flow (MAF) sensor (Cadillac OEM Part)
12%
Stuck closed EVAP canister purge valve (Cadillac OEM Part)
8%
Excessive fuel pressure regulator failure (Cadillac OEM Part)

3. Step-by-Step DIY Repair Guide for Cadillac Escalade-V

01
Clean MAF Sensor and Throttle Body

Use dedicated MAF cleaner to remove carbon buildup from sensor wires. on the Cadillac Escalade-V equipped with 6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque).

02
Check Short Term & Long Term Fuel Trims

Use live OBD-II scanner data; negative trims beyond -10% indicate the ECU is cutting fuel. on the Cadillac Escalade-V equipped with 6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque).

03
Inspect Fuel Injector Leak-Down

Perform a fuel pressure leak-down test to identify injectors leaking raw gasoline into cylinders while parked. on the Cadillac Escalade-V equipped with 6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque).

Other Common Fault Codes on Cadillac Escalade-V

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Cadillac Escalade-V:

4. Cadillac Escalade-V P0172 FAQs

What causes code P0172 to trigger on a Cadillac Escalade-V?

On the Cadillac Escalade-V (6.2L Handbuilt Supercharged V8 (682HP / 653 lb-ft torque)), P0172 is most frequently caused by Faulty or leaking fuel injector or Contaminated Mass Air Flow (MAF) sensor.

Where is the OBD-II port located on my Cadillac Escalade-V?

On the Cadillac Escalade-V, the 16-pin DLC diagnostic connector is located Driver lower dash assembly next to footwell light. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Cadillac Escalade-V with code P0172?

Driveable short distances, but unburnt fuel can damage catalytic converters. Given that P0172 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.