P0137 on Buick Envision
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Buick Envision (2021–2026, 2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD)).
1. Symptoms of P0137 on Buick Envision
When the Engine Control Module (ECM/PCM) on your Buick Envision (2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD)) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Buick Envision
Historical warranty claims and technical repair bulletins for Buick Envision point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Envision
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Buick Envision equipped with 2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD).
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Buick Envision equipped with 2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD).
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Buick Envision equipped with 2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD).
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Buick Envision equipped with 2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD).
Equipment for Diagnosing Buick Envision (P0137)
Buick Envision OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Buick Envision.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Envision
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Envision:
4. Buick Envision P0137 FAQs
What causes code P0137 to trigger on a Buick Envision?
On the Buick Envision (2.0L Turbo 4-Cyl (228HP / 258 lb-ft AWD)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Buick Envision?
On the Buick Envision, the 16-pin DLC diagnostic connector is located Driver side lower dash trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Envision with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.