U0104 on Buick Encore GX
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Buick Encore GX (2020–2026, 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)).
1. Symptoms of U0104 on Buick Encore GX
When the Engine Control Module (ECM/PCM) on your Buick Encore GX (1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Buick Encore GX
Historical warranty claims and technical repair bulletins for Buick Encore GX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Encore GX
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Verify power feed to radar sensor. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Execute optical/radar alignment procedure if bumper was removed. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Clear DTCs and test cruise on highway. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Equipment for Diagnosing Buick Encore GX (U0104)
Buick Encore GX OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Buick Encore GX.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Encore GX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Encore GX:
4. Buick Encore GX U0104 FAQs
What causes code U0104 to trigger on a Buick Encore GX?
On the Buick Encore GX (1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Buick Encore GX?
On the Buick Encore GX, the 16-pin DLC diagnostic connector is located Under driver side lower dash near knee panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Encore GX with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.