P0112 on Buick Encore GX
Factory diagnostic protocol and troubleshooting wire for fault code P0112 specifically for the Buick Encore GX (2020–2026, 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)).
1. Symptoms of P0112 on Buick Encore GX
When the Engine Control Module (ECM/PCM) on your Buick Encore GX (1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)) logs fault code P0112, drivers commonly observe:
2. Most Likely Causes on Buick Encore GX
Historical warranty claims and technical repair bulletins for Buick Encore GX point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Encore GX
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0112 to note engine RPM, load, and voltage when the fault triggered. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Inspect the electrical connector and wiring harness related to P0112 for chafing, corrosion, moisture, or pin push-out. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Buick Encore GX equipped with 1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP).
Equipment for Diagnosing Buick Encore GX (P0112)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Buick Encore GX.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Encore GX
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Encore GX:
4. Buick Encore GX P0112 FAQs
What causes code P0112 to trigger on a Buick Encore GX?
On the Buick Encore GX (1.2L Turbo 3-Cyl (137HP) / 1.3L Turbo 3-Cyl (155HP)), P0112 is most frequently caused by IAT sensor shorted to ground or Damaged wiring harness.
Where is the OBD-II port located on my Buick Encore GX?
On the Buick Encore GX, the 16-pin DLC diagnostic connector is located Under driver side lower dash near knee panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Encore GX with code P0112?
Yes. ECM assumes intake air is 280°F+. Given that P0112 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.