U0073 on Buick Enclave
Factory diagnostic protocol and troubleshooting wire for fault code U0073 specifically for the Buick Enclave (2020–2026, 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
1. Symptoms of U0073 on Buick Enclave
When the Engine Control Module (ECM/PCM) on your Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) logs fault code U0073, drivers commonly observe:
2. Most Likely Causes on Buick Enclave
Historical warranty claims and technical repair bulletins for Buick Enclave point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Enclave
Remove any aftermarket insurance dongles, GPS trackers, or scan tools plugged into the DLC port. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Inspect braided ground straps on engine and transmission. Clean all contact surfaces to bare metal. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Scan all modules on vehicle. Note which modules are online and which are offline to pinpoint the break in the network daisy-chain. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Verify 60 ohms across Pins 6 and 14 with battery disconnected. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Clear DTCs from all modules and road test to verify error-free network transmission. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Equipment for Diagnosing Buick Enclave (U0073)
Buick Enclave OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Buick Enclave.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Enclave
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Enclave:
4. Buick Enclave U0073 FAQs
What causes code U0073 to trigger on a Buick Enclave?
On the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)), U0073 is most frequently caused by Loose or corroded ground connection on transmission or frame or Faulty Transmission Control Module (TCM) or ABS module pulling bus down.
Where is the OBD-II port located on my Buick Enclave?
On the Buick Enclave, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Enclave with code U0073?
No. Bus is shut down due to excessive transmission errors, leaving vehicle in unpredictable limp mode. Given that U0073 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.