P2195 on Buick Enclave
Factory diagnostic protocol and troubleshooting wire for fault code P2195 specifically for the Buick Enclave (2020–2026, 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
1. Symptoms of P2195 on Buick Enclave
When the Engine Control Module (ECM/PCM) on your Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) logs fault code P2195, drivers commonly observe:
2. Most Likely Causes on Buick Enclave
Historical warranty claims and technical repair bulletins for Buick Enclave point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Enclave
Check exhaust manifold near Bank 1 Sensor 1 for cracks or blown gaskets sucking in fresh air. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Check B1S1 AFR sensor output. On Toyota/Lexus, 3.3V is stoichiometric; a sensor stuck at 4.0V+ indicates lean bias. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Briefly spray unlit propane into intake. If sensor voltage does not quickly drop rich, the sensor element is poisoned. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Install a new genuine OEM Denso / Bosch upstream A/F sensor. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Clear DTCs, reset ECU learned trims, and road test. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Equipment for Diagnosing Buick Enclave (P2195)
Buick Enclave OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Buick Enclave.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Enclave
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Enclave:
4. Buick Enclave P2195 FAQs
What causes code P2195 to trigger on a Buick Enclave?
On the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)), P2195 is most frequently caused by Contaminated or failing upstream Air-Fuel Ratio (AFR) / O2 sensor or Exhaust manifold crack or gasket leak before the sensor.
Where is the OBD-II port located on my Buick Enclave?
On the Buick Enclave, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Enclave with code P2195?
Caution. ECU may over-enrich fuel mixture trying to compensate for a falsely reported lean signal. Given that P2195 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.