P0116 on Buick Enclave
Factory diagnostic protocol and troubleshooting wire for fault code P0116 specifically for the Buick Enclave (2020–2026, 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
1. Symptoms of P0116 on Buick Enclave
When the Engine Control Module (ECM/PCM) on your Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) logs fault code P0116, drivers commonly observe:
2. Most Likely Causes on Buick Enclave
Historical warranty claims and technical repair bulletins for Buick Enclave point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Enclave
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0116 to note engine RPM, load, and voltage when the fault triggered. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Inspect the electrical connector and wiring harness related to P0116 for chafing, corrosion, moisture, or pin push-out. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Equipment for Diagnosing Buick Enclave (P0116)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Buick Enclave.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Buick Enclave
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Enclave:
4. Buick Enclave P0116 FAQs
What causes code P0116 to trigger on a Buick Enclave?
On the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)), P0116 is most frequently caused by Stuck open thermostat or Air pocket in cooling system.
Where is the OBD-II port located on my Buick Enclave?
On the Buick Enclave, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Enclave with code P0116?
Caution. Verify engine is not overheating. Given that P0116 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.