P0024 on Buick Enclave: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0024 (P0024: Exhaust Camshaft Position Timing Over-Advanced (Bank 2)) specifically on the Buick Enclave (2020–2026, 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).
1. Symptoms of P0024 on Buick Enclave
When the Engine Control Module (ECM/PCM) on your Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) logs fault code P0024, drivers commonly observe:
2. Most Likely Causes on Buick Enclave
Historical warranty claims and technical repair bulletins for Buick Enclave point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Buick Enclave
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether P0024 is static or intermittent. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Visually inspect the physical component (Bank 2 Exhaust Cam Phaser), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).
Other Common Fault Codes on Buick Enclave
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Enclave:
4. Buick Enclave P0024 FAQs
What causes code P0024 to trigger on a Buick Enclave?
On the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)), P0024 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Bank 2 Exhaust Cam Phaser) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Buick Enclave?
On the Buick Enclave, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Buick Enclave with code P0024?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that P0024 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.