P0155 on 2019 BMW i4
Technical troubleshooting wire for fault code P0155 specifically tailored for the 2019 BMW i4. Includes wiring sensor pinouts, freeze frame PID parameters, and step-by-step diagnostic tree.
Common 2019 i4 Symptoms
- Check Engine Light on immediately after cold start
- Slightly increased cold-start emissions
- No major driving performance issues once engine reaches full operating temperature
Likely Root Causes on 2019 i4
- Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor
- Blown O2 heater fuse in under-hood fuse block
- Corroded or broken heater power/ground wiring
- Faulty heater driver circuit in the PCM
Step-by-Step Fix Protocol for 2019 BMW i4
Connect an OBD-II scanner to the DLC port under the driver dashboard. Record engine RPM, Short Term / Long Term Fuel Trim (STFT/LTFT), and engine coolant temperature at the moment P0155 set.
Inspect the sensor connector on the 2019 i4 engine bay. Use a multimeter to verify reference voltage (5.0V / 12.0V) and ground continuity.
Replace the verified defective component using OEM or equivalent grade parts. Clear DTC P0155 and complete an EPA drive cycle to verify readiness monitors set to READY.
Equipment for Diagnosing 2019 BMW i4 (P0155)
2019 BMW i4 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for 2019 BMW i4.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.