P0125 on Audi Q5
Factory diagnostic protocol and troubleshooting wire for fault code P0125 specifically for the Audi Q5 (2020–2026, 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV).
1. Symptoms of P0125 on Audi Q5
When the Engine Control Module (ECM/PCM) on your Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV) logs fault code P0125, drivers commonly observe:
2. Most Likely Causes on Audi Q5
Historical warranty claims and technical repair bulletins for Audi Q5 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi Q5
Check that engine coolant is at full mark and no external radiator or hose leaks exist. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Start cold engine and watch ECT climb. If it plateaus below 170°F (77°C) while driving, thermostat is stuck open. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Drain 1 gallon of coolant, remove thermostat housing bolts, install new OEM temperature-rated thermostat (typically 180°F–195°F) with jiggle valve at 12 o'clock. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Fill cooling system with 50/50 prediluted coolant, run engine with spill-free funnel to purge air bubbles. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Verify scan tool Fuel System Status changes from 'Open Loop' to 'Closed Loop' within 5 minutes. on the Audi Q5 equipped with 2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV.
Equipment for Diagnosing Audi Q5 (P0125)
OEM Thermostat & Gasket Assembly
Direct-replacement thermostat calibrated to factory operating temperature for Audi Q5.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi Q5
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi Q5:
4. Audi Q5 P0125 FAQs
What causes code P0125 to trigger on a Audi Q5?
On the Audi Q5 (2.0L TFSI Turbo / 3.0L Turbo V6 (SQ5 349HP) / 55 TFSI e PHEV), P0125 is most frequently caused by Thermostat stuck open or opening prematurely or Low engine coolant level / air pocket around ECT sensor.
Where is the OBD-II port located on my Audi Q5?
On the Audi Q5, the 16-pin DLC diagnostic connector is located Left side under driver steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi Q5 with code P0125?
Yes, for short distances. Fuel economy will drop 15–25% as the engine remains trapped in open-loop enrichment. Given that P0125 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.