B1325 on Audi A4: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code B1325 (B1325: Device Power 1 Circuit Voltage Below Threshold (BCM)) specifically on the Audi A4 (2020–2026, 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)).
1. Symptoms of B1325 on Audi A4
When the Engine Control Module (ECM/PCM) on your Audi A4 (2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)) logs fault code B1325, drivers commonly observe:
2. Most Likely Causes on Audi A4
Historical warranty claims and technical repair bulletins for Audi A4 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi A4
Interface with the diagnostic port or system console using verified scanning hardware. Record freeze-frame data, active sub-codes, and timestamps to isolate whether B1325 is static or intermittent. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Visually inspect the physical component (Main BCM Ground Wire), connector pins, and associated wiring harnesses for signs of corrosion, thermal melting, or loose grounding clips. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Measure reference voltages and resistance thresholds against manufacturer factory specifications. Replace any component failing nominal impedance tolerances. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Install genuine OEM replacement hardware or execute registry / service commands. Ensure all mounting bolts are torqued to factory specifications. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Erase the fault code from non-volatile memory. Perform a standard verification cycle (e.g. 15-minute mixed drive or system stress benchmark) to ensure monitors reset to 'Ready' state without recurrent fault flags. on the Audi A4 equipped with 2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP).
Other Common Fault Codes on Audi A4
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi A4:
4. Audi A4 B1325 FAQs
What causes code B1325 to trigger on a Audi A4?
On the Audi A4 (2.0L TFSI Turbo 4-Cyl (EA888 Gen 4 201HP–261HP)), B1325 is most frequently caused by Component aging, oxidation, or degraded internal circuit element (Main BCM Ground Wire) or Wiring harness abrasion, loose terminal pin, or ground voltage float.
Where is the OBD-II port located on my Audi A4?
On the Audi A4, the 16-pin DLC diagnostic connector is located Under driver side dashboard near hood release lever (pink/purple port). Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi A4 with code B1325?
Caution. Limited operation permitted only to reach a nearby repair facility or backup critical personal files. Given that B1325 carries a High severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.