FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0507AcuraAcura MDX HubAll Acura P0507Medium Severity

P0507 on Acura MDX: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0507 (Idle Control System RPM Higher Than Expected - Diagnosis) specifically on the Acura MDX (2022–2026, 3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD)).

Acura MDX
DIY Parts Estimate
$40 - $250 (DIY Throttle Relearn: $0)
MDX OEM Fitment
Shop Labor Quote
$180 – $380
Based on $130/hr labor
Drivability Status
Drivable (Short Trip)
Medium urgency level
Est. DIY Time
45 – 90 Min
Basic hand tools
Check P0507 On Another Acura Model:
Acura MDXAcura Integra

1. Symptoms of P0507 on Acura MDX

When the Engine Control Module (ECM/PCM) on your Acura MDX (3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD)) logs fault code P0507, drivers commonly observe:

Engine idles at 1,000+ RPM in park/neutral on Acura MDX (3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD))
RPM surges or hunts at red lights on Acura MDX (3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD))
Check Engine Light illuminated on Acura MDX (3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD))
Acura MDX OBD-II Port Location
The 16-pin diagnostic connector is located Driver side lower dash assembly. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Acura MDX

Historical warranty claims and technical repair bulletins for Acura MDX point to the following failure distribution:

55%
Intake manifold vacuum leak (Acura OEM Part)
25%
Carbon buildup causing sticky electronic throttle body (Acura OEM Part)
12%
Uncalibrated idle air volume after battery disconnect (Acura OEM Part)
8%
Faulty PCV valve stuck open (Acura OEM Part)

3. Step-by-Step DIY Repair Guide for Acura MDX

01
Check for Unmetered Vacuum Leaks

Spray brake cleaner around intake manifold gaskets; an RPM change reveals the leak location. on the Acura MDX equipped with 3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD).

02
Clean Throttle Body & Carbon Deposits

Gently clean carbon soot around throttle blade using throttle cleaner and microfiber towel. on the Acura MDX equipped with 3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD).

03
Perform Idle Air Volume Relearn Procedure

Follow vehicle-specific ignition key on/off timing sequence or use OBD scanner to reset baseline idle. on the Acura MDX equipped with 3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD).

Other Common Fault Codes on Acura MDX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Acura MDX:

4. Acura MDX P0507 FAQs

What causes code P0507 to trigger on a Acura MDX?

On the Acura MDX (3.5L i-VTEC V6 (290HP) / 3.0L Turbo V6 (Type S 355HP / SH-AWD)), P0507 is most frequently caused by Intake manifold vacuum leak or Carbon buildup causing sticky electronic throttle body.

Where is the OBD-II port located on my Acura MDX?

On the Acura MDX, the 16-pin DLC diagnostic connector is located Driver side lower dash assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Acura MDX with code P0507?

Driveable, but braking distance may increase slightly due to high engine idle. Given that P0507 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.