P0155 on Jeep: Symptoms, Causes & Fix
Official technical diagnostic wire for fault code P0155 specifically affecting Jeep vehicles (Grand Cherokee, Wrangler, Gladiator, Compass).
Select Your Jeep Model for P0155:
1. Common Symptoms on Jeep Vehicles
When Jeep Engine Control Modules (ECM) trigger fault code P0155, drivers typically report:
2. Root Causes on Jeep Engines
Historical diagnostic claims across Jeep engines point to the following failure distribution:
3. Step-by-Step Fix Protocol for Jeep
Inspect the O2 HTR fuse in the engine fuse box with a test light or multimeter. on Jeep engines.
Unplug the sensor connector and measure resistance between the two heater pins. An open circuit (infinite ohms / OL) confirms a dead internal heater. on Jeep engines.
Remove faulty sensor and install a new OEM oxygen sensor with built-in heater. on Jeep engines.
Clear DTCs and allow engine to cool down, then restart to confirm P0155 does not return. on Jeep engines.
Equipment for Diagnosing Jeep (P0155)
Jeep OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Jeep.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
4. Jeep P0155 Frequently Asked Questions
What does code P0155 mean on a Jeep?
On Jeep vehicles, P0155 indicates that the Engine Control Module (ECM) detected o2 sensor heater circuit malfunction (bank 2 sensor 1). This typically points to Burnt-out heating element inside the Bank 2 Sensor 1 O2 sensor or Blown O2 heater fuse in under-hood fuse block.
Can I continue driving my Jeep with code P0155?
Yes. The sensor will take longer to warm up, causing brief open-loop fuel delay on cold starts. Because this code carries a Medium severity rating on Jeep powertrains, we recommend scanning live data values promptly to prevent secondary damage.
How much does it cost to fix code P0155 on a Jeep?
Estimated DIY parts cost ranges from $120 - $350 (DIY: $45 - $120), while professional shop repairs at an authorized Jeep dealership or independent specialist typically range from $180 to $380 including diagnostic labor.