P0300 on Dodge: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P0300 (P0300: Random or Multiple Cylinder Misfire Detected) specifically affecting Dodge vehicles (Charger, Challenger, Durango, Hornet).
1. Symptoms of P0300 on Dodge
When the Engine Control Module (ECM/PCM) on your Dodge logs fault code P0300, drivers commonly observe:
2. Most Likely Causes on Dodge
Historical warranty claims and technical repair bulletins for Dodge point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge
Plug a handheld OBD-II scanner into the 16-pin port under the dashboard. Check if specific cylinder codes like P0301 (Cylinder 1) or P0304 (Cylinder 4) accompany P0300. on Dodge vehicles (Charger, Challenger).
Remove the ignition coils, use a spark plug socket with ratchet to unthread spark plugs. Inspect electrode tips for carbon buildup, oil fouling, or burnt gaps. Replace with OEM iridium plugs gapped to spec. on Dodge vehicles (Charger, Challenger).
Perform an ignition swap test: Swap coil from a suspected misfiring cylinder to an adjacent cylinder. Clear codes and re-scan. If the misfire moves, replace the faulty coil. on Dodge vehicles (Charger, Challenger).
Inspect PCV hoses, intake boot, and vacuum lines for cracking or hissing sounds while engine idles. Smoke test the intake if necessary. on Dodge vehicles (Charger, Challenger).
Add a bottle of premium fuel injector cleaner (e.g. Chevron Techron). Clear the OBD-II codes with your scanner and take the car on a 15-minute drive cycle to confirm readiness monitors reset. on Dodge vehicles (Charger, Challenger).
P0300 Guides by Dodge Model
Select your specific Dodge model below for exact OBD-II DLC port locations, wiring diagrams, and engine displacement specs:
Other Common Diagnostic Codes on Dodge
Troubleshoot other high-frequency Check Engine Light fault codes reported across Dodge vehicles:
4. Dodge P0300 FAQs
What causes code P0300 to trigger on a Dodge?
On Dodge vehicles, P0300 is most frequently caused by Worn or fouled spark plugs and damaged spark plug wires or Failing ignition coils or coil packs. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Dodge with code P0300?
No. Driving with a flashing check engine light causes irreversible catalytic converter damage. Given that P0300 carries a Critical severity rating on Dodge vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P0300 on a Dodge?
DIY replacement parts typically range between $100 - $600 (DIY: $30 - $120). If serviced at an authorized Dodge dealership, expect an additional $120–$250 in professional labor based on their $120/hr hourly rate.