MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0150 on Honda: Symptoms, Causes & Fix

O2 Sensor Circuit Malfunction (Bank 2 Sensor 1)

Official technical diagnostic wire for fault code P0150 specifically affecting Honda vehicles (Civic, Accord, CR-V, Pilot, HR-V).

Sensor Voltage Ref
0.1V – 5.0V Ref
Honda Factory Standard
CAN Bus Speed
500 kbps CAN-FD
ISO 15765-4 Diagnostic Bus
Drivability Status
Drivable (Short Trip)
High urgency level
Est. Repair Cost
$130 - $380 (DIY: $45 - $130)
Parts & Labor DIY
Model-Specific Diagnostic Wires

Select Your Honda Model for P0150:

8 Models Available

1. Common Symptoms on Honda Vehicles

When Honda Engine Control Modules (ECM) trigger fault code P0150, drivers typically report:

Check Engine Light illuminated on Honda Powertrains
Increased fuel consumption on V6/V8 engines on Honda Powertrains
Rough idle or slight stumbling during acceleration on Honda Powertrains
Rich or lean exhaust smell on Honda Powertrains

2. Root Causes on Honda Engines

Historical diagnostic claims across Honda engines point to the following failure distribution:

55%
Failing Bank 2 upstream oxygen sensor (Honda OEM Part)
25%
Damaged wiring or melted harness on Bank 2 exhaust manifold (Honda OEM Part)
12%
Exhaust manifold gasket leak on Bank 2 (Honda OEM Part)
8%
Blown O2 sensor heater circuit fuse (Honda OEM Part)

3. Step-by-Step Fix Protocol for Honda

01
Locate Bank 2 Upstream Sensor

Identify Bank 2 (the cylinder bank that does NOT contain Cylinder 1). Locate the upstream O2 sensor before the catalytic converter. on Honda engines.

Required Tool: Engine Bay Inspection Light
02
Inspect Wiring & Measure Heater Resistance

Check the 4-wire or 5-wire harness for damage. Measure heater resistance across pins (typically 4–15 ohms). on Honda engines.

Required Tool: Digital Multimeter
03
Replace Bank 2 Sensor 1

Use an O2 sensor socket to remove the old sensor, thread in new OEM replacement, and torque securely. on Honda engines.

Required Tool: 7/8 O2 Sensor Socket, Ratchet, Penetrating Oil
04
Clear Trouble Codes & Test Drive

Clear DTCs and monitor Bank 2 Short Term Fuel Trim (STFT) to verify fuel control restoration. on Honda engines.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Honda (P0150)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Honda OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Honda.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for HondaVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

4. Honda P0150 Frequently Asked Questions

What does code P0150 mean on a Honda?

On Honda vehicles, P0150 indicates that the Engine Control Module (ECM) detected o2 sensor circuit malfunction (bank 2 sensor 1). This typically points to Failing Bank 2 upstream oxygen sensor or Damaged wiring or melted harness on Bank 2 exhaust manifold.

Can I continue driving my Honda with code P0150?

Yes, for limited driving. Bank 2 cylinders will operate in open-loop fail-safe mode. Because this code carries a High severity rating on Honda powertrains, we recommend scanning live data values promptly to prevent secondary damage.

How much does it cost to fix code P0150 on a Honda?

Estimated DIY parts cost ranges from $130 - $380 (DIY: $45 - $130), while professional shop repairs at an authorized Honda dealership or independent specialist typically range from $180 to $380 including diagnostic labor.