P0120 on Buick: Symptoms, Causes & Fix
Official technical diagnostic wire for fault code P0120 specifically affecting Buick vehicles (Enclave, Encore GX, Envision, Envista).
Select Your Buick Model for P0120:
1. Common Symptoms on Buick Vehicles
When Buick Engine Control Modules (ECM) trigger fault code P0120, drivers typically report:
2. Root Causes on Buick Engines
Historical diagnostic claims across Buick engines point to the following failure distribution:
3. Step-by-Step Fix Protocol for Buick
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code P0120 to note engine RPM, load, and voltage when the fault triggered. on Buick engines.
Inspect the electrical connector and wiring harness related to P0120 for chafing, corrosion, moisture, or pin push-out. on Buick engines.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on Buick engines.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on Buick engines.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on Buick engines.
Equipment for Diagnosing Buick (P0120)
VVT Oil Control Solenoid Valve
Restores accurate camshaft timing and oil pressure regulation on Buick.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
4. Buick P0120 Frequently Asked Questions
What does code P0120 mean on a Buick?
On Buick vehicles, P0120 indicates that the Engine Control Module (ECM) detected throttle/pedal position sensor/switch a circuit. This typically points to Faulty Throttle Position Sensor (TPS) or Worn throttle body gears.
Can I continue driving my Buick with code P0120?
No. Throttle response may be disabled or locked in Limp Mode. Because this code carries a Critical severity rating on Buick powertrains, we recommend scanning live data values promptly to prevent secondary damage.
How much does it cost to fix code P0120 on a Buick?
Estimated DIY parts cost ranges from $140 - $420, while professional shop repairs at an authorized Buick dealership or independent specialist typically range from $180 to $380 including diagnostic labor.