P0443 on Acura: Symptoms, Causes & Fix
Official technical diagnostic wire for fault code P0443 specifically affecting Acura vehicles (MDX, RDX, TLX, Integra, ZDX).
Select Your Acura Model for P0443:
1. Common Symptoms on Acura Vehicles
When Acura Engine Control Modules (ECM) trigger fault code P0443, drivers typically report:
2. Root Causes on Acura Engines
Historical diagnostic claims across Acura engines point to the following failure distribution:
3. Step-by-Step Fix Protocol for Acura
Find the purge valve mounted on the intake manifold with one vacuum line leading to the intake and one to the charcoal canister. on Acura engines.
Unplug 2-pin connector and measure resistance across terminals with multimeter. Typical spec is 14–30 ohms. If open (OL) or shorted (0 ohms), solenoid is dead. on Acura engines.
Remove purge valve and blow into it. A healthy de-energized purge valve should be 100% sealed. If air passes through, the internal seal is stuck open. on Acura engines.
Disconnect quick-release vapor lines, unbolt mounting bracket, snap new OEM purge valve into place, and reconnect electrical plug. on Acura engines.
Clear DTCs with scanner and verify EVAP monitor completes. on Acura engines.
Equipment for Diagnosing Acura (P0443)
OEM Tethered Fuel Gas Cap with O-Ring
Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
4. Acura P0443 Frequently Asked Questions
What does code P0443 mean on a Acura?
On Acura vehicles, P0443 indicates that the Engine Control Module (ECM) detected evap system purge control valve circuit malfunction. This typically points to Failed EVAP purge solenoid coil (open or shorted internally) or Broken or frayed wiring harness to purge valve connector.
Can I continue driving my Acura with code P0443?
Yes. Safe to drive, but engine may experience hard starting after refueling at gas station. Because this code carries a Medium severity rating on Acura powertrains, we recommend scanning live data values promptly to prevent secondary damage.
How much does it cost to fix code P0443 on a Acura?
Estimated DIY parts cost ranges from $90 - $250 (DIY: $25 - $70), while professional shop repairs at an authorized Acura dealership or independent specialist typically range from $180 to $380 including diagnostic labor.